COMING SOON to the Market:  

sticNstac tm Releasable Cable Holders - (Sticnstacs) - are patented and UL listed cable/wire positioning devices for securing NMSC. Once the switch/outlet boxes are placed on the wood framing at residential construction sites, you can drop your heavy tool belt. You won't be needing the old school hammer, pounds of different size staples, staple puller, even ear plugs any longer in order to run the wire home to the circuit breaker panel. All you'll need is a lightweight pouch, a pair of wire strippers, and a roll of polypropylene sticNstacs. They can be used on the fly, or they can be *PRE-POSITIONED ahead of time* at positioning points throughout the job site *PRIOR to running the wire*, rather than hammering staples over wires into position, and running the wire ALL AT THE SAME TIME - a very slow and awkward process; either way you're saving a ton of time and money. 

~ This  PROCESS is revolutionary in the trade! ~ 

Peel  sticNstacs off the roll & with the simple alignment tool and place them in the middle of the stud with one second of thumb pressure, and the patented vulcanizing adhesive creates an instant permanent bond, even in cold weather.  Yes, they can be used on metal also. Then, simply run the wire all the way home by placing it in the open sticNstac and snap the polypropylene jaws closed, tight and secure, then on to the next! The sticNstac jaws are releasable if you need to make adjustments, repairs or changes. And yes, they are stack-able!  

BONUS: 

You can save up to 50' -100' of wire or more per average house because of ZERO wasted material at each box! 

How?  With one sticNstac pre-installed 8" above the box, you can strip just the right amount of wire, place it in the box, then snap it securely in the sticNstac and then move on.  Often an extra foot or two of unstripped wire is shoved into the box because that first staple is hard to set, and the extra wire is cut to length & stripped later. Unnecessary wire waste!

That's real time, money and material saved!

That's Impressive!

Last, but certainly not least, sticNstacs are UL listed and approved as cable positioning devices, while standard metal staples are NOT!  SticNstac's are incapable of damaging wire or creating conditions for arc faults due to their 1. non-conductive materials, and   2. the method by which they are applied (no hammer strikes are used).

 Electrically conductive metal staples applied by hammer strikes are capable of misalignment or over-hammering, damaging wire insulation, creating conditions leading to potential arc faults that could creating conditions leading to electrical/structure fires.

This on-going fire hazard potential has existed for 

70+ years!

It would seem quite obvious that electrical code needs some serious up-dating to address this on-going 

fire hazard! 

sticNstac is the COMPLETLY SAFE alternative to hammered metal staples for wire positioning & securing.